Arduino radio hc-12

Introduction

LoRa, hc12, hc-12

• Frequency band is from 433.4 MHz to 473.0 MHz
• 100 channels with a stepping of 400 KHz between each channel
• Transmitting power is from -1dBm (0.79mW) to 20dBm (100mW). A half-duplex 20 dBm (100 mW) transmitter
• Receiving sensitivity is from -117dBm (0.019pW) to -100dBm (10pW)

Connect a 22 µF to 1 mF reservoir capacitor in parallel with the HC-12 "Gnd" and "Vcc" pins.

Set

Pins:

• “Set” pin of the module to Ground (set the pin to low logic level).

Code:

SoftwareSerial(rxPin, txPin, inverse_logic)

AT commands. The most important commands are

1. AT – test command. It will return OK if AT interface is enabled
2. AT+Bxxxx – set serial port baud rate. For example, AT+B57600 set baud rate to 57600bps
3. AT+Cxxx – set radio channel. Channels start from 001 at 433,4MHz. Each next channel adds 400kHz. Channel 100 is 473,0MHz. AT+C002 will set frequency to 433,8MHz. Two HC-12 devices that creates a wireless link have to operate on the same frequency
4. AT+FUx – set device mode: FU1, FU2, FU3 or FU4. Two HC-12 devices that creates a wireless link have to use the same mode
5. AT+Px – set device transmitting power. For example AT+P2 sets power to 2dBm (1.6mW)
   1. -1dBm (0.8mW)
   2. 2dBm (1.6mW)
   3. 5dBm (3.2mw)
   4. 8dBm (6.3mW)
   5. 11dBm (12mW)
   6. 14dBm (25mW)
   7. 17dBm (50mW)
   8. 20dBm (100mW)
6. AT+RX – retrieve all parameters: mode, channel, baud rate, power
7. AT+V – retrieve module version
8. AT+DEFAULT – reset module parameters to default settings