Beam Electronics. Brass wire electronics

From wikiluntti
Revision as of 17:30, 25 March 2026 by Mol (talk | contribs) (→‎Introduction)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Introduction

Electronics and art.


https://bhoite.com/ for example, see https://bhoite.com/sculptures/photon2-lander/

https://www.youtube.com/@MohitBhoite/shorts

  • 1/32″ (0.8mm) thick brass rods or bare 20 AWG (0.8mm) brass or copper wire.
  • Weller WES50 soldering iron, Hakko FX888D, or any 60W (and above) temperature controlled iron. Set the temperature of the iron to 400C, and use liberal amount of flux. Use a brass sponge to keep the tip clean.
  • Clean the joints with a #0000 grade steel wool
Retrieved from "https://wiki.luntti.net/index.php?title=Beam_Electronics._Brass_wire_electronics&oldid=15606"