DIY: PVC Flute

Introduction

PVC Flute

Instructions

Flute design by Nicolas Bras.

• 30 mm same pipe; Cut in half. Mark the center
• 410 mm electric pvc pipe. Locate 22 mm from the end; and glue the 30mm pipe. Drill the mark 9.5 mm drill bit.
• 20 mm wood dowel as a block
• Gradually shorten the pipe until you get A
• Make the other holes a millimeter smaller than indicated in the blueprint.

Exercise

• The effect of pipe diameter.
• The effect of hole diameter.
• Make other models: change the pitch (eg G major; 20 mm)
• Change the scale.

References

Nicolas Brass https://www.youtube.com/watch?v=Obpa9bzpzvQ