Creality Ender-3 V3 SE

Introduction

https://wiki.creality.com/en/ender-series/ender-3-v3-se

https://ender3-tuning.blogspot.com/2024/10/fine-tuning-printer-settings-for.html

First Layer problems

PLA:No need to use a glue stick. Some Isopropyl Alcohol and wipe down the bed between prints, and it'll print perfectly.

• Rough first layer: Caused by nozzle too close to bed. Adjust Z-offset and run calibration test.
• Gaps between lines: Caused by nozzle too far from bed. Level the bed and increase first layer height and width.
• Poor adhesion: Caused by low bed temperature, dirty bed, or incorrect adhesive. Clean the bed, raise the temperature, and use suitable adhesive.
• Inconsistent first layer: Caused by different filament types or printer models.

Adjust z offset

• 

  The difference of different Z heights.

Z offset test.

Initial Z Offset: After auto-leveling, the Z Offset is usually set around -2.35 mm.

Sticking problem

Adhesion.

Use glue.

Weird first layer. Nozzle too close to the bed? Bed not hot enough? https://www.reddit.com/r/3Dprinting/comments/64n0t3/weird_first_layer_nozzle_too_close_to_the_bed_bed/

Increase/ decrease by 0.1.