Creality Ender-3 V3 SE: Difference between revisions
From wikiluntti
| Line 2: | Line 2: | ||
== First Layer problems == | == First Layer problems == | ||
* Rough first layer: Caused by nozzle too close to bed. Adjust Z-offset and run calibration test. | |||
* Gaps between lines: Caused by nozzle too far from bed. Level the bed and increase first layer height and width. | |||
* Poor adhesion: Caused by low bed temperature, dirty bed, or incorrect adhesive. Clean the bed, raise the temperature, and use suitable adhesive. | |||
* Inconsistent first layer: Caused by different filament types or printer models. | |||
=== Sticking problem === | === Sticking problem === | ||
Revision as of 16:23, 23 March 2026
Introduction
First Layer problems
- Rough first layer: Caused by nozzle too close to bed. Adjust Z-offset and run calibration test.
- Gaps between lines: Caused by nozzle too far from bed. Level the bed and increase first layer height and width.
- Poor adhesion: Caused by low bed temperature, dirty bed, or incorrect adhesive. Clean the bed, raise the temperature, and use suitable adhesive.
- Inconsistent first layer: Caused by different filament types or printer models.
Sticking problem
Adhesion.
Use glue.
