Instrument cluster BMW 5 F10: Difference between revisions

From wikiluntti
VisualWikitext
Line 105: Line 105:


Rig
Rig
* https://opensimracing.com/collections/plans

Revision as of 23:12, 6 February 2026

Introduction

BMW5 F10 (2010-2017).

CANbus

CarCluster + ESP32 https://github.com/r00li/CarCluster

  • Please use arduino ESP32 core versions lower than 3.1.x until further notice as there is an issue with one of the included libraries that prevents the ESP from booting up with wifi enabled. Just install the latest 3.0.x version. Alternatively you can use it with wifi disabled, which should also work.

Connection Wiring

  • CANbus wiring BMW5 F10.

    CANbus wiring BMW5 F10.

F10
Cluster pin Connect to Comment
1, 2 +12V
4, 5 Through a NTC (10k?) Optional: Outside temp sensor
7, 8 GND (same GND)
11 +12 V Wakeup signal
6 CAN H Connect to canbus interface
12 CAN L Connect to canbus interface


References: https://github.com/r00li/CarCluster/blob/main/Misc/README_WIRING_BMW_F.md

ESP32 + Can

  • MCP2515 CAN bus module
  • 12V 1A power supply

https://github.com/r00li/CarCluster/blob/main/Misc/README_WIRING_JUMPERS.md

Caption text
CANbus interface pin Connect to Comment
INT ESP pin D2
CS ESP pin D5
SCK ESP pin D18
MISO ESP pin D19
MOSI ESP pin D23
GND ESP GND
VCC ESP VIN +5V if ESP is powered from USB

See the fuel level simulation from the github.

FFBeast

https://ffbeast.github.io/

  • Howerboard/Scooter motor: "The motor’s power is determined by the width of the stator, the diameter of the stator, and the number of strands in the motor winding. The most powerful items have stator width 30mm and 300mm magnets. It is coupled with 5 strand in motor winding." Motor Weight:
    • 30mm magnets/stator - 2.9 kg
    • 25mm magnets/stator - 2.6 kg
    • 20mm magnets/stator - 2.3 kg

Electronic parts

Pedals

sim racing pedals

Pedal rig


Hydraulic pedals sim racing

Cockpit

Rig

Retrieved from "https://wiki.luntti.net/index.php?title=Instrument_cluster_BMW_5_F10&oldid=15238"