Parkside 2.0 Ah 12V A3 battery X12v: Difference between revisions
From wikiluntti
| Line 1: | Line 1: | ||
== Introduction == | == Introduction == | ||
Battery management system BMS; battery protection circuit. | |||
See https://positron96.gitlab.io/projects/parkside-battery-protection/index.html for 20V battery. | |||
== Connectors == | == Connectors == | ||
Revision as of 22:36, 7 November 2025
Introduction
Battery management system BMS; battery protection circuit.
See https://positron96.gitlab.io/projects/parkside-battery-protection/index.html for 20V battery.
Connectors
- ID, tells the product which battery type is plugged it. Without the proper connection, the charger may overcharge, or ignore the battery
- T, Thermistor. The battery temperature; without it, the product may not accept the battery. See https://electronics.stackexchange.com/questions/10588/why-are-there-3-pins-on-some-batteries
(Reddit:) The tool supplies 5 V to the "T" pin, which, if everything is fine, the battery switches a 20 kOhm nominal NTC resistor to ground. Because the tool has a 10 kOhm resistor in series with its "T" pin the voltage drops to 3.3 V and the tool is able to detect that and start working. (https://www.reddit.com/r/batteries/comments/jwfwit/cordless_tool_battery_terminal_identification/)
See https://www.reddit.com/r/Parkside/comments/1jgixf2/parkside_batteries_wont_charge/
