Pimoroni Galactic Unicorn Hello World: Difference between revisions
From wikiluntti
| Line 14: | Line 14: | ||
IDE's | IDE's | ||
* Thonny is the da facto | * Thonny is the da facto | ||
* [https://dev.to/blues/your-first-steps-with-raspberry-pi-pico-and-visual-studio-code-4jbd VS Studio]: MicroPico (the id is paulober.pico-w-go). If not found use this https://github.com/microsoft/vscode/issues/108147 | * [https://dev.to/blues/your-first-steps-with-raspberry-pi-pico-and-visual-studio-code-4jbd VS Studio]: MicroPico (the id is paulober.pico-w-go). If not found use this https://github.com/microsoft/vscode/issues/108147 because some Linux distros use OpenVSX. | ||
== Fonts == | == Fonts == | ||
Revision as of 11:15, 30 September 2023
Introduction
583 RGB leds in 53x11 grid. Raspberry Pi Pico W (microcontroller), speaker with amplifier, two (2) I2C Stemma/qt sensor sockets, a light sensor (phototransistor) facing front and nine (9) control buttons, a reset button, JST-PH battery connector.
Connecting
Programming
Raspberry Pi Pico can be programmed using Micropython or C/C++. This will deal only with MicroPython.
To upload your file to Pico, it need to be put into bootloader mode: hold down the bootsel button while plugging the USB cable: it should show up as a drive called RPI-RP2.
IDE's
- Thonny is the da facto
- VS Studio: MicroPico (the id is paulober.pico-w-go). If not found use this https://github.com/microsoft/vscode/issues/108147 because some Linux distros use OpenVSX.
Fonts
Stationary, centred, scrolling text.
