DIY: PVC Flute: Difference between revisions
From wikiluntti
| Line 7: | Line 7: | ||
== Instructions == | == Instructions == | ||
* 30 mm same pipe; Cut in half. Mark the center | * [[File:Diy flute.svg|thumb|Flute design by Nicholas Bras. ]]30 mm same pipe; Cut in half. Mark the center | ||
* 410 mm electric pvc pipe. Locate 22 mm from the end; and glue the 30mm pipe. Drill the mark 9.5 mm drill bit. | * 410 mm electric pvc pipe. Locate 22 mm from the end; and glue the 30mm pipe. Drill the mark 9.5 mm drill bit. | ||
* 20 mm wood dowel as a block | * 20 mm wood dowel as a block | ||
Revision as of 12:41, 30 August 2023
Introduction
PVC Flute
Theory
Instructions
Flute design by Nicholas Bras. - 410 mm electric pvc pipe. Locate 22 mm from the end; and glue the 30mm pipe. Drill the mark 9.5 mm drill bit.
- 20 mm wood dowel as a block
- Gradually shorten the pipe until you get A
- Make the other holes a millimeter smaller than indicated in the blueprint.
Exercise
- The effect of pipe diameter.
- The effect of hole diameter.
- Make other models: change the pitch (eg G major; 20 mm)
- Change the scale.
References
Nicholas Brass https://www.youtube.com/watch?v=Obpa9bzpzvQ
