DIY: PVC Flute: Difference between revisions
From wikiluntti
| Line 17: | Line 17: | ||
* The effect of pipe diameter. | * The effect of pipe diameter. | ||
* The effect of hole diameter. | * The effect of hole diameter. | ||
* Make other models: change the pitch (eg G major; 20 mm) | |||
* Change the scale. | |||
== References == | == References == | ||
Nicholas Brass https://www.youtube.com/watch?v=Obpa9bzpzvQ | Nicholas Brass https://www.youtube.com/watch?v=Obpa9bzpzvQ | ||
<nowiki><youtube></nowiki>[https://www.youtube.com/watch?v=Obpa9bzpzvQ Obpa9bzpzvQ]<nowiki></youtube></nowiki> | |||
Revision as of 12:39, 30 August 2023
Introduction
PVC Flute
Theory
Instructions
- 30 mm same pipe; Cut in half. Mark the center
- 410 mm electric pvc pipe. Locate 22 mm from the end; and glue the 30mm pipe. Drill the mark 9.5 mm drill bit.
- 20 mm wood dowel as a block
- Gradually shorten the pipe until you get A
- Make the other holes a millimeter smaller than indicated in the blueprint.
Exercise
- The effect of pipe diameter.
- The effect of hole diameter.
- Make other models: change the pitch (eg G major; 20 mm)
- Change the scale.
References
Nicholas Brass https://www.youtube.com/watch?v=Obpa9bzpzvQ
<youtube>Obpa9bzpzvQ</youtube>
