Inkstitch machine embroidery: Difference between revisions
From wikiluntti
| Line 53: | Line 53: | ||
| 9 | | 9 | ||
| For micro stepping configuration | | For micro stepping configuration | ||
|- | |- | ||
| 8mm linear slide | | 8mm linear slide | ||
Revision as of 13:27, 28 February 2026
Introduction
Forum: https://inkscape.org/forums/embroidery/
The machine
https://inkstitch.org/tutorials/embroidery-machine/
3d printed parts: https://www.thingiverse.com/thing:3216283
Parts list
| Item | Length | # | |
|---|---|---|---|
| Nema 17 stepper | 3 | Anything that suits 3D printers or similar applications | |
| Nema 23 stepper | 1 | This drives sewing, bigger is better | |
| Stepper driver TB6600 | 1 | Or similar to suit sewing machine stepper (Nema23) | |
| Arduino uno | 1 | ||
| GRBL shield for uno | 1 | Make sure it is equipped with 4 stepper driver places | |
| DRV8825 | 3 | Stepper drivers for Nema17 steppers | |
| Jumpers | 9 | For micro stepping configuration | |
| 8mm linear slide | 400mm | 4 | Stainless rods or better |
| LM8UU | 8 | 8mm linear bearings | |
| 624ZZ bearings | 6 | Tightening bearings for belt | |
| 8mm GT2 belt | 3M | Or 3x 800mm | |
| GT2 pulley 16 Teeth | 3 | Suitable for nema17 steppers | |
| Gear and belt for machine | Timing belt or chain, to keep machine on sync. |
"Driving stepper with closed loop operation."
