DIY: PVC Flute: Difference between revisions
From wikiluntti
| Line 7: | Line 7: | ||
== Instructions == | == Instructions == | ||
[[File:Diy flute.svg|thumb|Flute design by Nicolas Bras. ]] | |||
* 30 mm same pipe; Cut in half. Mark the center | |||
* 410 mm electric pvc pipe. Locate 22 mm from the end; and glue the 30mm pipe. Drill the mark 9.5 mm drill bit. | * 410 mm electric pvc pipe. Locate 22 mm from the end; and glue the 30mm pipe. Drill the mark 9.5 mm drill bit. | ||
* 20 mm wood dowel as a block | * 20 mm wood dowel as a block | ||
Latest revision as of 12:42, 30 August 2023
Introduction
PVC Flute
Theory
Instructions
- 30 mm same pipe; Cut in half. Mark the center
- 410 mm electric pvc pipe. Locate 22 mm from the end; and glue the 30mm pipe. Drill the mark 9.5 mm drill bit.
- 20 mm wood dowel as a block
- Gradually shorten the pipe until you get A
- Make the other holes a millimeter smaller than indicated in the blueprint.
Exercise
- The effect of pipe diameter.
- The effect of hole diameter.
- Make other models: change the pitch (eg G major; 20 mm)
- Change the scale.
References
Nicolas Brass https://www.youtube.com/watch?v=Obpa9bzpzvQ
