DIY: PVC Flute: Difference between revisions
From wikiluntti
(Created page with "== Introduction == PVC Flute == Theory == == Instructions == * 30 mm same pipe; Cut in half. Mark the center * 410 mm electric pvc pipe. Locate 22 mm from the end; and glue the 30mm pipe. Drill the mark 9.5 mm drill bit. * 20 mm wood dowel as a block * Gradually shorten the pipe until you get A * Make the other holes. == References == Nicholas Brass https://www.youtube.com/watch?v=Obpa9bzpzvQ") |
|||
| Line 11: | Line 11: | ||
* 20 mm wood dowel as a block | * 20 mm wood dowel as a block | ||
* Gradually shorten the pipe until you get A | * Gradually shorten the pipe until you get A | ||
* Make the other holes. | * Make the other holes a millimeter smaller than indicated in the blueprint. | ||
== References == | == References == | ||
Nicholas Brass https://www.youtube.com/watch?v=Obpa9bzpzvQ | Nicholas Brass https://www.youtube.com/watch?v=Obpa9bzpzvQ | ||
Revision as of 13:36, 30 August 2023
Introduction
PVC Flute
Theory
Instructions
- 30 mm same pipe; Cut in half. Mark the center
- 410 mm electric pvc pipe. Locate 22 mm from the end; and glue the 30mm pipe. Drill the mark 9.5 mm drill bit.
- 20 mm wood dowel as a block
- Gradually shorten the pipe until you get A
- Make the other holes a millimeter smaller than indicated in the blueprint.
References
Nicholas Brass https://www.youtube.com/watch?v=Obpa9bzpzvQ
