Beam Electronics. Brass wire electronics: Difference between revisions
From wikiluntti
| Line 9: | Line 9: | ||
* 1/32″ (0.8mm) thick brass rods or bare 20 AWG (0.8mm) brass or copper wire. | * 1/32″ (0.8mm) thick brass rods or bare 20 AWG (0.8mm) brass or copper wire. | ||
* Weller WES50 soldering iron, Hakko FX888D, or any 60W (and above) temperature controlled iron. | * Weller WES50 soldering iron, Hakko FX888D, or any 60W (and above) temperature controlled iron. Set the temperature of the iron to 400C, and use liberal amount of flux. Use a brass sponge to keep the tip clean. | ||
* Clean the joints with a #0000 grade steel wool | |||
Latest revision as of 17:30, 25 March 2026
Introduction
Electronics and art.
https://bhoite.com/ for example, see https://bhoite.com/sculptures/photon2-lander/
https://www.youtube.com/@MohitBhoite/shorts
- 1/32″ (0.8mm) thick brass rods or bare 20 AWG (0.8mm) brass or copper wire.
- Weller WES50 soldering iron, Hakko FX888D, or any 60W (and above) temperature controlled iron. Set the temperature of the iron to 400C, and use liberal amount of flux. Use a brass sponge to keep the tip clean.
- Clean the joints with a #0000 grade steel wool
