Fc-22 Gas sensor Arduino: Difference between revisions

From wikiluntti
VisualWikitext
 
(2 intermediate revisions by the same user not shown)
Line 4: Line 4:


== Theory ==
== Theory ==
Connect Vcc, GND and Analog Output to Arduino Analog A0 pin (see https://www.instructables.com/How-to-use-MQ2-Gas-Sensor-Arduino-Tutorial/). Also, there is Digital Output.


<syntaxhighlight lang="C">
<syntaxhighlight lang="C">
Line 17: Line 19:


void loop() {
void loop() {
   float rzero = gasSensor.getRZero();
   float rzero = gasSensor.getRZero(); #Calibaration. Actually it takes ~24h time.
   float ppm = gasSensor.getPPM();
   float ppm = gasSensor.getPPM();
   Serial.println(ppm);
   Serial.println(ppm);
Line 26: Line 28:


See https://github.com/Ravenneo/CO2-sensor
See https://github.com/Ravenneo/CO2-sensor
Calibration https://hackaday.io/project/3475-sniffing-trinket/log/12363-mq135-arduino-library


== Exercises ==
== Exercises ==

Latest revision as of 18:06, 18 November 2024

Introduction

MQ-2

Theory

Connect Vcc, GND and Analog Output to Arduino Analog A0 pin (see https://www.instructables.com/How-to-use-MQ2-Gas-Sensor-Arduino-Tutorial/). Also, there is Digital Output. 

#include "MQ135.h"

MQ135 gasSensor = MQ135(A5);

int ppm = gasSensor.getPPM();

void setup() {
  Serial.begin(9600);
}

void loop() {
  float rzero = gasSensor.getRZero(); #Calibaration. Actually it takes ~24h time.
  float ppm = gasSensor.getPPM();
  Serial.println(ppm);

  delay(1000);
}

See https://github.com/Ravenneo/CO2-sensor

Calibration https://hackaday.io/project/3475-sniffing-trinket/log/12363-mq135-arduino-library

Exercises

Code 1

Code 2

Code 3

Retrieved from "https://wiki.luntti.net/index.php?title=Fc-22_Gas_sensor_Arduino&oldid=12713"