Beam Electronics. Brass wire electronics: Difference between revisions
From wikiluntti
(Created page with "== Introduction == Electronics and art. https://bhoite.com/ for example, see https://bhoite.com/sculptures/photon2-lander/ https://www.youtube.com/@MohitBhoite/shorts") |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 7: | Line 7: | ||
https://www.youtube.com/@MohitBhoite/shorts | https://www.youtube.com/@MohitBhoite/shorts | ||
* 1/32″ (0.8mm) thick brass rods or bare 20 AWG (0.8mm) brass or copper wire. | |||
* Weller WES50 soldering iron, Hakko FX888D, or any 60W (and above) temperature controlled iron. Set the temperature of the iron to 400C, and use liberal amount of flux. Use a brass sponge to keep the tip clean. | |||
* Clean the joints with a #0000 grade steel wool | |||
Latest revision as of 17:30, 25 March 2026
Introduction
Electronics and art.
https://bhoite.com/ for example, see https://bhoite.com/sculptures/photon2-lander/
https://www.youtube.com/@MohitBhoite/shorts
- 1/32″ (0.8mm) thick brass rods or bare 20 AWG (0.8mm) brass or copper wire.
- Weller WES50 soldering iron, Hakko FX888D, or any 60W (and above) temperature controlled iron. Set the temperature of the iron to 400C, and use liberal amount of flux. Use a brass sponge to keep the tip clean.
- Clean the joints with a #0000 grade steel wool
