FlySky FS-i6 and FS-iA10B: Difference between revisions
From wikiluntti
(→iBUS) |
(→iBUS) |
||
| Line 9: | Line 9: | ||
=== iBUS === | === iBUS === | ||
Unfortunately not all FlySky receivers support the iBus. The following ones are recommended: FS-X6B, FS-IA6B and FS-A8S. (Not the one I have:() but the [https://medium.com/@werneckpaiva/how-to-read-rc-signal-with-arduino-using-flysky-ibus-73448bc924eb Medium article] includes FS-iA10B receiver, also. | Unfortunately not all FlySky receivers support the iBus. The following ones are recommended: FS-X6B, FS-IA6B and FS-A8S. (Not the one I have:() but the [<ref>https://medium.com/@werneckpaiva/how-to-read-rc-signal-with-arduino-using-flysky-ibus-73448bc924eb Medium article</ref>] includes FS-iA10B receiver, also. | ||
Revision as of 15:13, 21 November 2025
Introduction
Technical details
Flysky FS-i6X 10CH 2.4GHz AFHDS RC Sender
iBUS: iBUS protocol.
iBUS
Unfortunately not all FlySky receivers support the iBus. The following ones are recommended: FS-X6B, FS-IA6B and FS-A8S. (Not the one I have:() but the [[1]] includes FS-iA10B receiver, also.
https://github.com/bmellink/IBusBM:
- A half-duplex to control multiple servos and motors using a single digital line.
- The values received for each servo channel are between 1000 (hex eE8) and 2000 (hex 7D0) with neutral sub trim setting, which corresponds with the pulse width in microseconds for most servos.
See the example wiring on that Github page or below:
-
Example wiring. The rightmost pins are for iBUS signal and the leftmost for sensor iBUS.
