View source for Instrument cluster BMW 5 F10

== Introduction ==

BMW5 F10 (2010-2017). 

CANbus

CarCluster + ESP32 https://github.com/r00li/CarCluster
* ''Please use arduino ESP32 core versions lower than 3.1.x until further notice as there is an issue with one of the included libraries that prevents the ESP from booting up with wifi enabled. Just install the latest 3.0.x version. Alternatively you can use it with wifi disabled, which should also work.''

== Connection Wiring ==

<gallery>
Bmw5 f11 instrumentCluster wiring.jpg|thumb|CANbus wiring BMW5 F10. 
</gallery>

{| class="wikitable"
|+ F10
|-
! Cluster pin !! Connect to !! Comment
|-
| 1, 2 || +12V || 
|-
| 4, 5 || Through a NTC (10k?) || Optional: Outside temp sensor
|-
| 7, 8 || GND (same GND) || 
|-
| 11 || +12 V || Wakeup signal
|-
| 6 || CAN H || Connect to canbus interface
|-
| 12 || CAN L || Connect to canbus interface
|}


References: https://github.com/r00li/CarCluster/blob/main/Misc/README_WIRING_BMW_F.md

== ESP32 + Can ==

* MCP2515 CAN bus module
* 12V 1A power supply
*

https://github.com/r00li/CarCluster/blob/main/Misc/README_WIRING_JUMPERS.md
{| class="wikitable"
|+ Caption text
|-
! CANbus interface pin !! Connect to !! Comment
|-
| INT || ESP pin D2 || 
|-
| CS || ESP pin D5 || 
|-
| SCK || ESP pin D18 || 
|-
| MISO || ESP pin D19 || 
|-
| MOSI || ESP pin D23 || 
|-
| GND || ESP GND || 
|-
| VCC || ESP VIN || +5V if ESP is powered from USB
|}

See the fuel level simulation from the github.