View source for Fixing of a Mobile phone

== Introduction ==

Display (screen) replacement

== Samsung Galaxy S10+ ==

Samsung Galaxy S10+
* SN: r58m78at7wf
* SM-G975F
* SM-G975FZWDNEE
* Dimensions: 157.6 x 74.1 x 7.8 mm3, 6.4", 1440x3040 pixels

Ifixit part number IF416-001-3 AMOLED (252€). 
Replacement guide: 
* https://www.ifixit.com/Guide/Samsung+Galaxy+S10++Screen+Replacement/136889
* https://www.youtube.com/watch?v=0ZZs7rv4ifA

Tools and parts:
* Suction cup
* iOpener: an insulated, heat-retaining bag. https://www.ifixit.com/Guide/iOpener+Instructions/11677
* isopropyl alcohol 

Also the adhesives are needed
* Display adhesive
* Rear cover adhesive

=== My fix ===

<gallery>
Mobile backcoverremoved.jpg| Tools needed to remove the backcover: heat gun, sucker and plectrum 
Mobile backremoved.jpg|Remove the backcover.
Mobile bottompart.jpg| Remove the bottom part. 
Mobile mainboard.jpg | Mainboard. Remove the camera module (upper left corner) and SIM card tray.
Mobile mainboardtoNew.jpg| Insert the mainboard to the new display. Remember to change the vibrator and phone plug.
Mobile checkthecables.jpg| Ensure that the cable looks similar and that the screen is of right size
Mobile working.jpg| Check that the phone works. The put the black plastic parts into their place
Mobile glueing.jpg| Glueing is difficult. 
</gallery>

Remove the backcover

Back cover's right edge
* Heat (to < 100˚C) back cover's right edge (there is less adhesive) for two (2) minutes.
* Suction cup to a center of right edge
* Slice through the right edge

Bottom edge
* Heat for 2 min

Remaining edges. Be careful with the corners.
* Remove the back cover from the frame.

The midframe
* Remove the nine 4mm Phillips screws from the to midframe.
* Loosen the plastic clips.
* Loosen the midframe from the notch on the left edge of the phone (near the power button).

* Disconnect the battery
* Remove the battery
* Find the plastic clips

Remove the main board
* Remove the camera
* Remove the vibrator
* Remove the phone audio plug
* Remove the SIM card

Insert all to the new display
* Glue the back cover