View source for Creality Ender-3 V3 SE

== Introduction ==

== First Layer problems ==

* Rough first layer: Caused by nozzle too close to bed. Adjust Z-offset and run calibration test.
* Gaps between lines: Caused by nozzle too far from bed. Level the bed and increase first layer height and width.
* Poor adhesion: Caused by low bed temperature, dirty bed, or incorrect adhesive. Clean the bed, raise the temperature, and use suitable adhesive.
* Inconsistent first layer: Caused by different filament types or printer models. 

=== Sticking problem ===

Adhesion.


Use glue.

=== ===

=== ===

=== ===